Sliding door repairs in Spokane Valley can be a tricky business. But with the right tools and equipment, you can get your door back to working order in no time. To start, you'll need to raise or lower the door above the guide with a screwdriver or Allen wrench. Lift it high enough to clear the track and roll smoothly.
Then, locate the two adjustment screws at the bottom of the door (on the face or edge of the door) and remove the plugs that cover them. If one side faces down, lift it until the door is level on the rail. If your door is still stuck, turn the two screws a quarter of a turn to lift the entire door. Then slide it just below the jamb and make sure the space is even. To complete your sliding glass door adjustment project, you'll need basic tools and materials, as well as an assistant to help you handle the door. To begin, insert a flat screwdriver into each hole and turn the screw completely counterclockwise.
This retracts the rollers, lowering the door. Outside, place a pair of easels with pads and remove any grilles, curtains, or removable curtains. Inside, tilt the top of the sliding door panel toward you and lift it off the bottom bar. Next, use a flathead screwdriver to gently pull each roller out of its pocket at the bottom of the door. Reinstall them by aligning each one's adjustment screw with its access hole and hitting the assemblies with a hammer.
Use a wooden block to protect the wheels. Once they're seated, pull them back as far as possible. To replace broken or cracked weatherstripping where the sliding and fixed panels overlap, loosen any staples with a flat screwdriver. Then grab one end and pull it out with a spatula. Remove any remaining staples with pliers and sink any broken ones with a hammer. The strip on the side of the jamb is usually stuck together.
If it's damaged, remove it and scrape off any adhesive residue with a spatula, taking care not to damage the finish. You can order new rollers for repairing sliding doors from manufacturers or online suppliers. If your rollers are full of dirt and debris, clean them thoroughly and add a few drops of lubricant to see if they spin freely. If your door still doesn't slide smoothly, it means that you need to adjust or replace your rollers. If you have pets that like to pet your mosquito net on your patio door, order a new one that's suitable for pets. Before removing your sliding glass door for maintenance, plan in advance for a suitable place where you can support it.
Look for the name of your door's manufacturer on its edge or its hardware's manufacturer on its roller. Using your hand or a screwdriver, gently pull out any swivel wheels from its bottom. After years of use, your sliding patio door may no longer work or look as good as it should. You can order rollers and other parts to repair sliding doors from wood warehouses and home centers or online. If your guide is full of dirt and debris, clean it thoroughly and add some lubricant to see if it slides easily. If not, you may need to adjust or replace your rollers.
When you're done with repairs, don't forget to check for wood rot in an exterior door frame – this minimizes your home's energy efficiency and leads to costly repairs. Whether you need products, services, repairs, or maintenance for your sliding doors in Spokane Valley, your Arbon equipment sales representative is here to help. With their help and these tips in mind, you'll be able to get your sliding doors back in working order in no time!.
